M.R.M.P. Silicone Fluid

Characteristics:

Greater  thermal stability.

Improved lubricating properties, including metal to plastic  and metal to metal surface.

• wider range of compatibility with organic materials.
• Higher resistance to oxidation and gumming.
• Like other dimethyl silicone oils these groups also possess the similar                           
• advantages what silicone oils generally offer, for e.g.
• Chemical and physiological inertness
• Low pour points
• Surface activity.

Typical Properties:

• MP Silicone Fluids: MP 1
• Colour: Clear straw

Viscosity:

• At 25°C: 100-150.
• Sp. Gravity Range at 25°C: 1.06 -1.08.
• Flash point °C: 310.

Thermal Stability:

The most important characteristic of M.R. M P Fluids is that their thermal stability is several times more than Dimethyl Silicone Fluids. Therefore M.R. MP fluids are particularly suitable for high temperature applications. The grades MP 1 and MP 2 are recommended for such severe service requirements.

Lubricating Properties:

M.R.MP series of fluids have much greater lubricating properties than Dimethyl silicone fluids. In addition, they have much greater compatibility with metallic soaps and other organic additives normally used in the formulation of various lubricants and greases designed for very high or low temperature applications.

Solubility:

 M.R. MP series of fluids are soluble in a wider range of organic solvents. Suitable solvents include alphatic and aromatic hydrocarbons and their halogen derivatives, alcohols, linear and cyclic ethers, keytones, esters such as amyl alcohol, acetone, butyl alcohol, benzene, chloroform, carbon tetrachloride, cyclohexene, dioxane, diethyl  ether, dimethyl foramide, toluene, tri-chloroethylene, xylene etc. unlike dimethyl silicone fluids, M.R. MP series are soluble in even aqueous alcohols. This property expands its area of application, which was limited till now due to poor solubility of normal silicone fluids.

Compressibility:

Compressibility of  M.R. MP series of fluids are much lower to that of dimethyl silicone fluids thereby finding uses in high temperature hydraulic transmission and where shear forces are extremely high.

Chemical Resistance:

M.R. MP series of fluids generally have little reactivity and only attacked by aggressive

Materials, such as concentrated mineral acids, free halogens, anhydrous homogenate hydrocarbons and super heated steam. They are resistant to water and most suitable for use in presence of plastics and most metals.

These figures are intended as a guide and should not be used in preparing specifications.

Silicone laboratory samples (SLM) are development products. Therefore, we cannot at present give any assurance of constant properties or of continues supplies in future.